Measure:histogram:mode - Agilent Technologies Infiniium 90000 Series Programmer's Manual

25
Measure Commands

:MEASure:HISTogram:MODE

Command
:MEASure:HISTogram:MODE [<source>]
The :MEASure:HISTogram:MODE command places the histogram mode
measurement into the Measurements tab of the oscilloscope's user
interface.
The source is specified with the :MEASure:SOURce command or with the
optional parameter following the command.
The :MEASure:HISTogram commands only apply to Meas Histogram math
functions, the histogram waveform, or memories containing histograms.
<source>
{ FUNCtion<F> | WMEMory<N> | HISTogram}
<F> An integer, 1- 16.
<N> An integer, 1- 4.
Example
This example places into the Measurements tab the mode of the histogram
stored in WMEMory1.
myScope.WriteString ":MEASure:HISTogram:MODE WMEMory1"
Query
:MEASure:HISTogram:MODE? [<source>]
The :MEASure:HISTogram:MODE? query returns the measurement
histogram's Mode value.
Returned Format
[:MEASure:HISTogram:MODE]<value>[,<result_state>]<NL>
<value>
The Mode value of the histogram.
<result_state> If SENDVALID is ON, the result state is returned with the measurement
result. Refer to the MEASure:RESults command, for a list of the result
states.
Example This example returns the Mode value of the current histogram and prints
the result to the computer's screen.
myScope.WriteString ":SYSTem:HEADer OFF"
myScope.WriteString ":MEASure:HISTogram:MODE? WMEMory1"
varHistMode = myScope.ReadNumber
Debug.Print FormatNumber(varHistMode, 0)
See Also
•
•
552
":FUNCtion<F>:MHIStogram"
":HISTogram:MODE"
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
on page 350
on page 374
' Response headers off.