Config Mac-Vlan Add Mac-Address - Extreme Networks ExtremeWare Command Reference Manual

config mac-vlan add mac-address

config mac-vlan add mac-address [any | <mac_address>] mac-group [any |
<group_number>] vlan <vlan name>
Description
Adds a MAC address as a potential member of a MAC-based VLAN.
Syntax Description
mac_address
group_number
vlan name
Default
N/A.
Usage Guidelines
The specified MAC address must be associated with an end station/host only, not a layer-2 repeater
device.
Adding a MAC address means that when the specified address is detected on a member port, as
specified by its group membership, it can participate in the VLAN.
At least one port must be enabled to use the MAC-based VLAN algorithm before any MAC addresses
can be added.
Example
Given ports enabled for MAC-based VLANs as follows:
enable mac-vlan mac-group any ports 16,17
enable mac-vlan mac-group 10 ports 11,12
The following command sets up the end-station with MAC address 00:00:00:00:00:01 to participate in
VLAN engineering via the MAC-enabled ports 16 or 17:
config mac-vlan add mac-address 00:00:00:00:00:01 mac-group any vlan engineering
MAC address 00:00:00:00:00:01 cannot get access via ports 11 or 12 because it is not configured for
mac-group 10.
The following command sets up the endstation 00:00:00:00:00:02 to participate in VLAN engineering
through the ports in group 10 (ports 11 or 12) or through ports 16 or 17 (enabled for any mac-group):
config mac-vlan add mac-address 00:00:00:00:00:02 mac-group 10 vlan engineering
ExtremeWare Software 7.0.0 Command Reference Guide
The MAC address to be added to the specified VLAN. Specified in the form
nn:nn:nn:nn:nn:nn.
any indicates that any MAC-address associated with the specified MAC group
may be a member.
The group number that should be associated with the specified MAC address.
Specified as an integer
any indicates that this MAC address can be associated with any MAC group.
The name of the VLAN with which this MAC address should associated.
config mac-vlan add mac-address
231