Show Multilink Alarms - Extreme Networks ExtremeWare Command Reference Manual

show multilink alarms

show multilink alarms
show multilink <groupname> [t1 | e1] alarms {detail}
Description
Displays alarms for a multilink group.
Syntax Description
groupname Specifies a previously created multilink group.
Default
N/A
Usage Guidelines
Use this command to display alarms that may have been received on any of the ports that make up a
multilink group. To display alarms on a T3 link, use the command:
show ports <portlist> t3 alarms
Example
The following command displays the alarms for T1 ports in the multilink group ml_example:
show multilink ml_example t1 alarms
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
E1 support was added in ExtremeWare v6.1.8w3.0.1b56 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
ExtremeWare 7.7 Command Reference Guide 2223