Run Diagnostics Cable - Extreme Networks ExtremeWare Command Reference Manual

Version 7.7
Hide thumbs Also See for ExtremeWare:
Table of Contents

Advertisement

High-Density Gigabit Ethernet Commands—Alpine 3800 and BlackDiamond 6800 Series Only

run diagnostics cable

run diagnostics cable port [<portlist> | all]
Description
Runs cable diagnostics values for the physical ports on a G24T
switch.
NOTE
This command is available only on the G24T3 module and on Summit 400 series switches. For more
information about troubleshooting commands in Extreme switches, refer to Chapter 13.
Syntax Description
portlist
Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
"3"
all
Specifies all
series ports.
Default
None
Usage Guidelines
Use this command to obtain the following cable diagnostics data for each selected port:
• Time and date of test
• Cable length
• Pair status
• Pair skew
• Pair swap
• Fault len
• Polarity
• Speed
To view cable diagnostics data, use the
To enable auto-diagnostics collection for selected ports, use the
command. To set the starting time for auto-diagnostics collection for selected ports, use the
command. To disable auto-diagnostics collection for selected ports, use the
diagnostics cable
disable diagnostics cable
command.
diagnostics cable
You cannot issue this command while the cable diagnostics process is in progress.
Example
The following command starts the Cable Diagnostics Module (CDM) to obtain cable diagnostics values
for ports 2:4 through 2-7:
2262
show diagnostics cable
command. To abort cable diagnostics current in progress, use the
3
module in a BlackDiamond 6800 series
command.
enable diagnostics cable
ExtremeWare 7.7 Command Reference Guide
configure
abort

Advertisement

Table of Contents
loading

This manual is also suitable for:

Extremeware 7.7

Table of Contents