Bearing Outer Race
Replacement (Clutch housing side) -
NOTE:
l
The outer race and bearing should be replaced as a
set.
l
Inspect and adjust the bearing preload whenever the
bearing is replaced.
1 .
Remove the outer race, 90 mm washer and oil
guide ring.
DRIVER
0 7 7 4 6 - 0 0 1 0 0 0 0
2.
Bearing Preload
NOTE: If any of the items listed below are replaced, the
bearing preload must be adjusted.
1 .
ATTACHMENT,
0 7 7 4 6 - 0 0 1 0 5 0 0
BEARING OUTER
R A C E
ATTACHMENT,
Adjustment
Remove the bearing outer race and 75 mm thrust
shim from the transmission housing by prying up
on the bearing outer race or by heating the housing
to about 100°C (212OF).
CAUTION: Do not reuse the thrust shim if the
outer race was pried out.
NOTE:
l
Let the transmission cool to the room tempera-
ture if the outer race was removed by heating
the case before adjusting the bearing preload.
of 100°C (212OF).
the outer race is replaced.
\
TRANSMISSION
HOUSING
mm
76
THRUST SHIM
Replace.