Bearing Outer Race Replacement - Honda Prelude 1993 Service Manual

Differential (Manual Transmissionl
Bearing Outer Race RePlacement
NOTE:
. T h e b e a r i n g o u t e r r a c e a n d t a p e r e d r o l l e r b e a r i n g
should be replaced as a set.
. Inspect and adlust the tapered roller bearing preload
whenever the tapered roller bearing is replaced.
1. Remove the oil seals from the transmission housing
a n d c l u t c h h o u s i n g ( s e e P a g e ' 1 5 5 )
2.
Drive the bearing outer race and thrust shim out of
t h e t r a n s m i s s i o n h o u s i n g , o r r e m o v e t h e b e a r i n g
outer race and thrust shim from the transmission
h o u s i n g b y h e a t i n g t h e t r a n s m i s s i o n h o u s i n g t o
a b o u t 2 1 2 " F ( 1 0 0 ' C ) w i t h a h e a t g u n .
CAUTION: Do not reus€ the thrust shim if the
outer racG was driven out.
N O T E : D o n o t h e a t t h e t r a n s m i s s i o n h o u s i n g i n
excess of 212'F (100'C).
TRANSMISSION
HOUSING:
ATTACHMENT,
5 2 x 5 5 m m
ORIVER
07749 - OOl(Xno
07715 - (X)10400
BEARING
OUTEF RACE
THRUST SHIM
:'----J)-4
1 5 - 6
THRUST SHIM
OUTER RACE
4.
Install the oil seal {see page 15-9).
3.
After installing the thrust shim. install 8n bearing
outer race in the transmission housing and clutch
housing using the special tools as shown.
NOTE:
. Installthe bearing outer race squarely.
. Check that there is no clearance between the
bearing outer race, thrust shim, and transmis-
sion housin9.
TRANSMISSION
HOUSING:
DRIVER
077a9 - (xn(xx)o
ATTACHMENT,
fi:l x 68 mm
077i16 - (x)los(x)
THNUST SHIM
CLUTCH
HOUSING:
- 00tqx)0
ATTACHMENT.
7 2 x t 5 m m
07746 - 0011}600
EEARING
OUTER
THRUST
DRIVER