Cisco MDS 9124 - Fabric Switch Reference page 332

do
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
do
Use the do command to execute an EXEC-level command from any configuration mode or submode.
Syntax Description
command
Defaults None.
Command Modes All configuration modes.
Command History Release
1.1(1)
Usage Guidelines Use this command to execute EXEC commands while configuring your switch. After the EXEC
command is executed, the system returns to the mode from which you issued the do command.
Examples
The following example disables the terminal session-timeout command using the do command in
configuration mode.
switch(config)# do terminal session-timeout 0
switch(config)#
The following example create, enables, and displays the interface from configuration mode.
switch(config)# int fc 3/1
switch(config-if)# no shut
switch(config-if)# do show interface fc 3/1
fc3/1 is trunking
Cisco MDS 9000 Family Command Reference
5-34
do command
Specifies the EXEC command to be executed.
Modification
This command was introduced.
Hardware is Fibre Channel
Port WWN is 20:81:00:05:32:00:4a:9e
Peer port WWN is 20:43:00:0c:88:00:4a:e2
Admin port mode is auto, trunk mode is on
Port mode is TE
Port vsan is 1
Speed is 2 Gbps
Transmit B2B Credit is 0
Receive B2B Credit is 255
Receive data field Size is 2112
Beacon is turned off
Trunk vsans (admin allowed and active) (1-10)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
5 minutes input rate 504 bits/sec, 63 bytes/sec, 0 frames/sec
5 minutes output rate 344 bits/sec, 43 bytes/sec, 0 frames/sec
69390 frames input, 4458680 bytes
(1-10)
()
()
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 5 D Commands