Debug All - Cisco MDS 9124 - Fabric Switch Reference

debug all

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug all
To enable debugging for all features on the switch, use the debug all command in EXEC mode. To
disable this command and turn off all debugging, use the no form of the command.
Syntax Description
This command has no arguments or keywords.
Defaults
Disabled.
Command Modes EXEC mode.
Command History Release
1.0(2)
Usage Guidelines
The no debug all command turns off all diagnostic output. Using the no debug all command is a
convenient way to ensure that you have not accidentally left any debug commands turned on.
Because debugging output takes priority over other network traffic, and because the debug all command
Caution
generates more output than any other debug command, it can severely diminish the performance of the
switch or even render it unusable. In virtually all cases, it is best to use more specific debug commands.
Examples The following example displays the system output when the debug all command is issued:
switch# debug all
Related Commands Command
show debug
Cisco MDS 9000 Family Command Reference
6-4
debug all
no debug all
Modification
This command was introduced.
Description
Displays the debug commands configured on the switch.
Chapter 6 Debug Commands
OL-16217-01, Cisco MDS SAN-OS Release 3.x