Table of Contents
Advertisement
IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
The following example disables the generation of ICMPv6 unreachable messages,
as appropriate, on an interface:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
28.30 show ipv6 interface
Use the show ipv6 interface command in user EXEC or privileged EXEC mode to
display the usability status of interfaces configured for IPv6.
Syntax
show ipv6 interface [brief] | [[
Parameters
•
brief—Displays a brief summary of IPv6 status and configuration for each
interface where IPv6 is defined.
•
interface-id
—Interface identifier about which to display information.
•
prefix—Prefix generated from a local IPv6 prefix pool.
Default Configuration
Option brief - all IPv6 interfaces are displayed.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
Use this command to validate the IPv6 status of an interface and its configured
addresses. This command also displays the parameters that IPv6 uses for
operation on this interface and any configured features.
If the interface's hardware is usable, the interface is marked up.
interface vlan 100
no ipv6 unreachables
exit
interface-id
] [prefix]]
28
588
Advertisement
Table of Contents
