QuadTech Guardian 6100 Plus Instruction Manual page 33

2.2
Check to make sure the Red Voltage Selector Switches on the rear panel agree with the
power source available. Depending on the power source the switch positions should be in
the up or down positions as shown in Figure 1-6 (AC Inlet Module & Voltage Selector
Switches).
NEVER TOUCH THE TEST LEADS IN ANY MANNER (this includes insulation on all wires and clips)
USE ALL PRECAUTIONS NECESSARY TO AVOID TOUCHING THE DEVICE UNDER TEST
Connect the instrument power cord to the source of proper voltage. The instrument is
to be used only with three wire grounded outlets.
Power is applied to the G6100 Plus by pressing the white [POWER] toggle switch on the
front panel to ON (1 position). The G6100 Plus unit should have a warm-up time of at
least 15 minutes prior to use.
DO NOT TURN INSTRUMENT POWER ON OR OFF WITH TEST DEVICES CONNECTED.
Note: Read the entire manual before operating the Guardian 6100 Plus instrument.
Operation
www.valuetronics.com
Startup
when the HIGH VOLTAGE IS APPLIED and red DANGER LED is ON.
WHEN THE RED DANGER LED IS ON OR FLASHING.
WARNING
WARNING
150799 Rev A3 Page 33 of 177