QuadTech Guardian 6100 Plus Instruction Manual page 157

STEP SETTING
01. Test Step
02. Test Mode
03. Device
04. Line Input
GB Switch
05.
06. Meter
07. High Limit
08.
Low Limit
09. Power
10. Test Time
11. CHNL (H-L)
PRESS FUNCTION KEY
STEP SETTING
01. Test Step
02. Test Mode
03. Device
1
X
10. Test Time
11. CHNL (H-L)
PRESS NUMBER KEYS
Scanner #1 is the internal 6000-07 Hipot/Leakage Current Scanner.
Channels 1 and 3 are available on Scanner #1. CH1 is used to provide the voltage to the
DUT to power it on. CH3 can be set to L or X.
NOTE:
lines it means that the channel is unavailable.
Interface
www.valuetronics.com
: 7
: LC
: UL2601
: NORMAL
OPEN
:
L - G
:
:
10.00mA
OFF
:
: VOLTAGE
: 3.0s
OFF
:
Remote Lock
: 7
: LC
: UL2601
SETUP SCANNER - 1
2 3 4 5 6 7 8
X X X X X X X
3.0s
OFF
Remote Lock
Figure 3-11: Scanner Programming Display: LC Mode
In the scanner setup menu, when the text appears ghost-like " " with dashed
SETUP
Offset Error
NEXT BOX
EXIT
Offset Error
150799 Rev A3
Use Function Key
Enter setup menu for scanner(s)
Use Numeric Keys then [ENTER]
Use the Numeric Key that corresponds to the Channel #
The Numeric Key acts as a toggle switch: X, H or L
Program the scanner channels
X = Not used
H = High (High voltage/current applied to this channel)
L = Low (This channel is the return)
Use Function Key [NEXT BOX] to setup next scanner
Use Function Key [EXIT] to exit scanner setup
In LC mode,
Page 157 of 177