Quick Setup Menu - Printronix SLPA8000 User Manual

QUICK SETUP Menu

QUICK SETUP
Print Intensity
Print Speed
Print Mode
Media Handling
Tear-Off Strip*
Paper Feed Shift
Label Length
Label Width
Ver Image Shift
Hor Image Shift
Orientation
Gap/Mark Sensor
Auto Calibrate
Active IGP Emul
Save Config.
Power-Up Config.
(cont. on next page)
–3* –15 to 15
1
6 ips* 1 to 10 ips
Transfer* Direct
6
Tear-Off
2
0.00 inches* -0.50 to X inches
2, 4
4 or 6 inches* 00.1 to 99.0 inches
4.1, 6.6, or 8.5 inches*
2
0.00 inches* -1.00 to X inches
2
0.00 inches* -1.00 to 1.00 inches
Portrait* Landscape
Disable* Mark
Run Calibrate
IGP/PGL* PPI/ZGL
IGP/VGL
1* 1 to 8
Factory* 1 to 8
QUICK SETUP Menu
Loading A Saved Configuration
Peel-Off Cut
3
5
4
00.1 to 4.1 inches
3
Inv. Portrait Inv. Landscape
Gap Advanced Gap
PPI/TGL PPI/IGL
Notes:
* = Default
1
Maximum value depends on the width of the printer
model and printhead.
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL).
3
Based on the current value setting for Label Length,
up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer
model.
5
Maximum value depends on model width and size of
DRAM installed.
6
Required for SLPA operation.
Continuous
Advanced Notch
PPI/STGL PPI/DGL
85