Adjusting The Voltage - Printronix SLPA8000 User Manual

Chapter 1
Installing The SLPA

Adjusting The Voltage

AC Power
Receptacle
Selected
Voltage
Facing
Arrows
Fuse Holder
Assembly
The facing arrows indicate the selected voltage setting. (Figure 6.). If the
setting is incorrect, adjust the voltage as follows:
1. Set the power switch to O (Off).
2. Insert the tip of a flat tip screwdriver into the slot above the fuse holder
assembly, and twist to remove the assembly.
3. Flip over the fuse holder assembly and make sure the fuse is in the active
fuse location.
NOTE: Refer to "Electrical" on page 249 for fuse electrical specifications.
4. Reinsert the fuse holder assembly. Make sure the facing arrows are
aligned properly.
32
Power
Switch
Active Fuse
Figure 6. Adjusting the Voltage
Slot