Optional Mounting Accessories; Mounting The Beacon - Printronix SLPA8000 User Manual

Chapter 1
Installing The SLPA
Figure 2. Mounting Hole Configuration
CAUTION
The mounting plates of the SLPA are 0.375 inches (9.25 mm) thick.
When mounting the SLPA, use screws that will secure the assembly into
place but will not penetrate deeper than 1/2 inch (12.7 mm) in the SLPA.
IMPORTANT
Retain cap screws in mounting holes that are not to be utilized.

Optional Mounting Accessories

See "Mounting Accessories" on page 255.

Mounting The Beacon

See "Mounting The Beacon" on page 254.
28