Table of Contents
Advertisement
Media Support Assembly
To remove media support assembly, follow the steps below and refer to
Figure 29.
1. Remove the top cover assembly (page 52).
2. Disconnect the port verifier cable from connector J3 on the controller
PCBA. (See Figure 13, page 63.)
3. Remove the two screws securing the parallel port to the rear panel. (See
Figure 13, page 63.)
4. Remove the two 3/16 inch hex head standoff screws securing the serial
port to the rear panel. (See Figure 13, page 63.)
5. Remove the four screws securing the controller PCBA. (See Figure 13,
page 63.) Leave the cables attached to the controller PCBA.
6. Gently swing the controller PCBA forward to gain access to the mounting
screws (1) of the media support assembly (2).
7. Remove the four mounting screws (1) and media support assembly (2).
1
Legend:
1)
Screw (4)
2)
Media Support Assembly
Figure 29. Media Support Assembly
Media Support Assembly
2
93
Advertisement
Table of Contents
Troubleshooting
