Program Table Edit/Save (Fnb03) - YASKAWA S-V Series User Manual

8 Operation of Digital Operator

8.2.2 Program Table Edit/Save (FnB03)

8.2.2

Program Table Edit/Save (FnB03)

This function edits and saves program tables. Saving a program table to flash memory after editing it ensures
that the data will be retained even after the control power has been turned off.
 Codes Displayed on the Program Table Editing Screen
For details on how to read the screen, refer to 8.1.3 Reading the Screen.
PGMSTEP POS
0 POS000
1 POS001
255 POS255
(1) Preparation
The following conditions must be met to edit and save program tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• The program must not be running or on hold.
• The program tables must not being saved by any other means than using the digital operator.
• The RES command must not being executed.
(2) Editing Program Table
The operating procedure when setting the acceleration (ACC) in program step 5 is explained here.
Step
1
2
3
4
5
∗
If setting is attempted in an operation prohibited state, it will not be possible to change the setting. In this case, make
the setting again by referring to (1) Preparation.
8-6
SPD RDST RSPD
SPD000 RDST000 RSPD000
SPD001 RDST001 RSPD001
SPD255 RDST255 RSPD255
Display after Operation
ACC DEC POUT
ACC000 DEC000 POUT000
ACC001 DEC001 POUT001
ACC255 DEC255 POUT255
Keys
Press the
main menu, and move the cursor with the
keys to select FnB03.
Press the
Move the cursor using the
keys (or the
select the article and program step of the program table
to be edited. For details on how to move the cursor,
refer to  Method for Moving the Cursor.
Press the key to move the cursor to the setting side
of the table.
Move the cursor with the
table settings with the
For details on how to set each field, refer to (3) Details
on How to Set Table Settings.
EVENT LOOP
EVT000 LOOP000 NEXT000
EVT001 LOOP001 NEXT001
EVT255 LOOP255 NEXT255
Operation
key to open the Utility Function Mode
key to view the FnB03 operation screen.
keys and
+ and + keys) to
keys, and change the
*
keys.
NEXT