Parameter List For Indexer Module - YASKAWA S-V Series User Manual

Parameter
No.
/SEL7
Setting
0
PnB0D
1
2
3
/S-ON
Setting
0 When input signal is ON (close), servomotor power is ON. Servomotor can be operated.
PnB0E
1 When input signal is OFF (open), servomotor power is ON. Servomotor can be operated.
2 Always servo ON
3 Always servo OFF
P-OT
Setting
0 When input signal is OFF (open), forward run is prohibited (forward overtravel).
PnB0F
1
When input signal is ON (close), forward run is prohibited (forward overtravel).
2
Forward run is always prohibited (forward overtravel).
3
Forward run is always enabled. (P-OT signal is not used.)
N-OT
Setting
0 When input signal is OFF (open), reverse run is prohibited (reverse overtravel).
PnB10
1 When input signal is ON (close), reverse run is prohibited (reverse overtravel).
2 Reverse run is always prohibited (reverse overtravel).
3 Reverse run is always enabled. (N-OT signal is not used.)
/DEC
Setting
0 Starts deceleration in homing when input signal is ON (close).
PnB11
1 Starts deceleration in homing when input signal is OFF (open).
2 Sets homing limit switch always ON.
3 Sets homing limit switch always OFF.
/RGRT
Setting
PnB12
0 Starts registration by switching input signal from OFF (open) to ON (close).
1 Starts registration by switching input signal from ON (close) to OFF (open).
2, 3 Does not start registration.
Name Setting Range
When input signal is ON (close), program table selection signal /SEL7 becomes active.
When input signal is OFF (open), program table selection signal /SEL7 becomes active.
Program table selection signal /SEL7 is always active.
Program table selection signal /SEL7 is always inactive.

10.1 Parameter List for INDEXER Module

Setting
Unit
0 to 3 –
Meaning
0 to 3 –
Meaning
0 to 3 –
Meaning
0 to 3 –
Meaning
0 to 3 –
Meaning
0 to 3 –
Meaning
(cont'd)
Factory When
Reference
Setting Enabled
0 After restart 6.1.2
0 After restart 5.3.1
0 After restart 5.3.2
0 After restart 5.3.2
0 After restart 6.4.2
0 After restart 6.2.2
10
10-5