Reading The Screen - YASKAWA S-V Series User Manual

8.1.3 Reading the Screen

• The SERVOPACK status is always displayed at the top left of the screen (
BB:
RUN:
A. :
PT NT:
P-OT:
N-OT:
P-LS:
N-LS:
NO-OP:
HBB:
∗
Overtravel and software limit indications are supported by the following software version.
INDEXER Module: Version 3 or later
SERVOPACK: Version 001B or later.
• The figure of editing screen used in the program tables, ZONE tables and JOG speed tables has the follow-
ing elements.

: The article and table number currently selected

: The article of the table

: The table number

: The table settings
Note: The line beneath POS000 shows that this indication is flashing. This line does not appear on the actual screen. Note
also that the part that flashes is referred to as the cursor in this document.
Base blocked
Servomotor is ON
Alarm/warning is in effect ( is the alarm/warning code).
Forward run and reverse run prohibited (Over travel)
Forward run prohibited (Over travel)
Reverse run prohibited (Over travel)
*
Forward software limit
*
Reverse software limit
Setting disabled or setting error
During hard wire base block

).
*
*
*
8.1 Overview
8
8-3