B.1 Understanding The Parameter Table - YASKAWA U1000 Series Technical Manual

B.1 Understanding the Parameter Table

B.1 Understanding the Parameter Table
 Control Modes, Symbols, and Terms
The table below lists terms and symbols used in this section to indicate which parameters are available in which control
modes.
Note: For detailed instructions on each control mode,
Symbol
Indicates the parameter is accessible in all control modes.
All Modes
Parameter is available when operating the drive with V/f Control.
V/f
Parameter is available when operating the drive with V/f with PG Control.
V/f w/PG
Parameter is available when operating the drive with Open Loop Vector.
OLV
Parameter is available when operating the drive with Closed Loop Vector.
CLV
Parameter is available when operating the drive with Open Loop Vector for PM motors.
OLV/PM
Parameter is available when operating the drive with Advanced Open Loop Vector for PM motors.
AOLV/PM
Parameter is available when operating the drive with Closed Loop Vector for PM motors.
CLV/PM
Indicates this parameter can be changed during run.
Motor 2 Refers to a second motor when the drive is operating two motors. Switch between these motors using the multi-function input terminals.
Note: If a parameter is not available in a certain control mode, the symbol for that control mode is grayed out.
402
Refer to Control Mode Selection on page
Table B.1 Symbols and Icons Used in the Parameter Table
30.
Description
YASKAWA ELECTRIC SIEP C710636 03A YASKAWA U1000 Technical Manual