Program Table Initialization (Fnb06) - YASKAWA S-V Series User Manual

8 Operation of Digital Operator

8.2.5 Program Table Initialization (FnB06)

8.2.5 Program Table Initialization (FnB06)

This function initializes the program tables and restores the settings on shipment from the factory.
(1) Preparation
The following conditions must be met to initialize the program table.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• The program must not be running or on hold.
• The program tables must not being saved by any other means than using the digital operator.
• The RES command must not being executed.
(2) Operating Procedure
Step
1
2
3
4
5
∗
If the
the display returns to the FnB06 operation screen. In this case, make the setting again by referring to (1) Preparation.
8-16
Display after Operation
key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and then
Keys
Press the key to open the Utility Function Mode
main menu, and move the cursor with the
keys to select FnB06.
Press the key to view the FnB06 operation screen.
Press the key to start program table initialization.
Do not turn off the control power supply until initial-
ization has been completed normally.
To cancel the FnB06 operation, press the
before pressing the
Utility Function Mode main menu without executing
the operation.
When program table initialization has been completed
–
normally, "Done." is displayed.
Press the key to return to the Utility Function
Mode main menu.
Operation
key
key. The display returns to the
*