Zone Table Initialization (Fnb07) - YASKAWA S-V Series User Manual

8.2.6 ZONE Table Initialization (FnB07)

This function initializes ZONE tables and restores the settings on shipment from the factory.
(1) Preparation
The following conditions must be met to initialize ZONE tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• The ZONE tables must not being saved by any other means than using the digital operator.
• The RES command must not being executed.
(2) Operating Procedure
Step Display after Operation
1
2
3
4
5
∗
If the key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and then
the display returns to the FnB07 operation screen. In this case, make the setting again by referring to (1) Preparation.
Keys
Press the key to open the Utility Function Mode
main menu, and move the cursor with the
keys to select FnB07.
Press the key to view the FnB07 operation screen.
Press the key to start ZONE table initialization.
Do not turn off the control power supply until initial-
ization has been completed normally.
To cancel the FnB07 operation, press the
before pressing the
Utility Function Mode main menu without executing
the operation.
When ZONE table initialization has been completed
–
normally, "Done." is displayed.
Press the key to return to the Utility Function
Mode main menu.
8.2 Operation of Utility Functions
Operation
*
key
key. The display returns to the
8
8-17