Zone Table Edit/Save (Fnb04) - YASKAWA S-V Series User Manual

8.2.3 ZONE Table Edit/Save (FnB04)

This function edits and saves ZONE tables. Saving a ZONE table to flash memory after editing it ensures that
the data will be retained even after the control power has been turned off.
 Codes Displayed on the ZONE Table Editing Screen
For details on how to read the screen, refer to 8.1.3 Reading the Screen.
ZONE
Number
0
1
31
(1) Preparation
The following conditions must be met to edit and save ZONE tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• The ZONE tables must not being saved by any other means than using the digital operator.
(2) Editing ZONE Tables
The operating procedure when setting ZONEN in ZONE number 5 is explained here.
Step Display after Operation
1
2
3
4
5
6
Repeat steps 3 to 6 to set the ZONE table. On completing the setting of all the ZONE tables to be used, save the
7
ZONE tables to flash memory by following the procedure in (3) Saving ZONE Tables.
∗
If setting is attempted in an operation prohibited state, it will not be possible to change the setting. In this case, make
the setting again by referring to (1) Preparation.
ZONEP ZONEN
ZP000 ZN000
ZP001 ZN001
ZP031 ZN031
Keys
8.2 Operation of Utility Functions
Operation
Press the key to open the Utility Function Mode
main menu, and move the cursor with the
keys to select FnB04.
Press the key to view the FnB04 operation screen.
Move the cursor using the
keys to select the ZONE table number to be edited. For
details on how to move the cursor, refer to  Method
for Moving the Cursor.
Press the key to move the cursor to the setting side
of the table.
Move the cursor using the
the ZONE boundary values using the
On pressing the key, the setting is entered and the
cursor returns to the ZONE table number side.
keys and
keys and change
*
keys.
8
8-11