Jog Speed Table Initialization (Fnb08) - YASKAWA S-V Series User Manual

8 Operation of Digital Operator

8.2.7 JOG Speed Table Initialization (FnB08)

8.2.7 JOG Speed Table Initialization (FnB08)

This function initializes JOG speed tables and restores the factory settings.
(1) Preparation
The following conditions must be met to initialize JOG speed tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• The JOG speed tables must not being saved by any other means than using the digital operator.
• The RES command must not being executed.
(2) Operating Procedure
Step
1
2
3
4
5
∗
If the
the display returns to the FnB08 operation screen. In this case, make the setting again by referring to (1) Preparation.
8-18
Display after Operation
key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and then
Keys
Press the key to open the Utility Function Mode
main menu, and move the cursor with the
keys to select FnB08.
Press the key to view the FnB08 operation screen.
Press the key to start JOG speed table initializa-
*
tion.
Do not turn off the control power supply until initial-
ization has been completed normally.
To cancel the FnB08 operation, press the
before pressing the
Utility Function Mode main menu without executing
the operation.
When JOG speed table initialization has been com-
–
pleted normally, "Done." is displayed.
Press the key to return to the Utility Function
Mode main menu.
Operation
key
key. The display returns to the