Nortel DMS-100 Series Reference Manual page 94
Extended peripheral module
Hide thumbs
Also See for DMS-100 Series:
- Replacement procedures (1100 pages) ,
- Maintenance manual (762 pages) ,
- Manual (543 pages)
Table of Contents
Advertisement
3-70 Datafilling BAS on RSC-S International
Basic call processing
Error messages for table RCCINV
Error message
Delete P-side links prior to
deleting the extension
Extension PEC must be MX86AA
XX does not support
extension
Info: NT7X05AA requires MX77
processor
Info: The remote PM must be
busied before this value can
be changed
Datafilling table RCCPSINV
Table remote cluster controller P-side link inventory (RCCPSINV) contains
only P-side link assignments for the RCO2. A maximum of 54 multiples of
P-side link information can be entered for the RCO2.
When an extension shelf is added, there are datafill limits. The datafill
limits applies to RCO2 P-side links that connect to the extension shelf. The
PCM-30 and D-channel handler (DCH) links connected to the extension
shelf can only be entered if an extension shelf is entered in RCCINV. All
the links that connect to the extension shelf must be changed from D30/DCH
to NILTYPE or DS30A in RCCPSINV. These links must be changed prior
to the deletion of the extension shelf from table RCCINV. A maximum of
DCH cards can be entered in table RCCPSINV.
The following procedure shows the datafill for table RCCPSINV. This
procedure only contains fields that apply to basic call processing. Refer to
297-8331-815 Standard 10.01 August 1999
(continued)
Note: Only two PCM-30 C-side links, 0 and 2, are necessary. The data
control table for P-side links, table RCCPSINV, requires link 1 to be
entered before link 2 can be entered. If only two links are required, link
1 remains ManB. You must enter for three links in this table.
(continued)
Explanation and action
A user tried to delete an extension
shelf that has P-side links entered in
table RCCPSINV.
A user tried to enter a PEC that is
different than MX86AA to the
extension shelf.
A user tried to add an extension shelf
to a peripheral that is not CPM.
A user tried to enter field PROCPEC
with AX74AA AX74AA instead of
MX77AA MX77AA. The user enters
the fields when NT7X05 is already
entered as an optional card.
A user tried to change protocols
before the user busied the PM.
—end—
Advertisement
Table of Contents
