Nortel DMS-100 Series Reference Manual page 201

Datafilling table LCMINV
The data assignment for the LCM and expanded line concentrating module
(LCNE) appears in table line concentrating module inventory (LCMINV).
Enter LCMEs off the RCO2 with the same values as LCMEs configured at
the host site.
The datafill example for table LCMINV shows only the fields that apply to
the ISDN on RSC. Refer to the data schema section of the Translations
Guide for a description of the other fields.
Datafilling table LCMINV
Subfield or
Field
refinement
LCMNM
SITE
FRNO
UNITNO
FRTYPE
EQPEC
Note: When you enter fields link information (LNKINFO) or link map (LNKMAP), do not assign
message links to the same physical interface card. When the interface card supports two or more
links, separate the message links by the number of links on the interface cards. This procedure
applies to all interface link types: DS-1, DS30, DS30A, or PCM-30. Table control issues a warning
if you attempt to assign message links on the same interface card. If you assign message links to
the same interface card, this procedure can cause an E1 outage if the card fails. An E1 outage is
the failure of all message links.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling ISDN on RSC-S International 3-177
Entry Explanation and action
see subfields Line concentrating module name. Enter the
LCM name. Subfields: SITE, FRNO, and
UNITNO.
alphanumeric Site. Enter the remote location site name.
0 to 511 Frame number. Enter the LCM frame number.
0 to1 Unit number. Enter the LCM unit number.
see list Frame type. Enter the frame type that contains
the peripheral module equipment. Enter CRSC
for the RCO2 shelf. Enter CEXT for the RCO2
extension shelf.
Enter the location of the LCM in fields SHPOS,
FLOOR, ROW, and FRPOS.
see list Frame equipment product engineering code
(PEC). Enter PEC for frame type, CRSC or
CEXT, where the LCME appears.
—continued—
ISDN operations
(continued)