Nortel DMS-100 Series Reference Manual page 414

4-164 Datafilling ISDN on RSC-S UK / Europe
ISDN operations
Datafilling table RCCINV
The Remote Cluster Controller Inventory (RCCINV) table contains
inventory data for the RCO2. Table RCCINV does not include inventory
data for the P-side links. Only fields that apply to the ISDN on RSC-S
appear in the datafill example for table RCCINV. Refer to the data design
section of the Translations Guide for a description of the other fields. The
inclusion of the ISP option card allows integration of the enhanced
D-channel handler (NTBX02BA) card in table DCHINV.
Datafilling table RCCINV
Subfield or
Field
refinement
FRMTYPE
ESA
WSXWACT
Note 1: An ESA warm switch of activity (SWACT) causes the loss of ISDN calls. An XPM06
supports ESA warm SWACT for ISDN calls with stability.
Note 2: The ISP is the designator of the enhanced ISDN signal processor (NTBX01BA) card.
Note 3: Make changes to fields with multiple entries in PROMPT mode only.
Note 4: When you enter data in field C-side link table (CSLNKTAB), you cannot assign message
links to the same physical interface card. When the interface card supports two or more links,
separate the message links by the number of links on the interface cards. This separation applies
to all interface link types. The interface link types are DS-1, DS30, DS30A, or PCM-30. Table
control issues a warning if you make an attempt to assign message links on the same interface
card. The assignment of message links to the same interface card can cause an E1 outage if the
card fails. An E1 outage is the failure of all message links.
297-8331-815 Standard 10.01 August 1999
(continued)
Entry
RCEI
Y or N
Y or N
—continued—
Explanation and action
Frame type. Enter RCEI for ISDN on RCO2.
Emergency stand alone. Enter Y. Enter data
for WXSWACT if the RCO2 has the ESA option.
Warm exit switch activity. If ESA is set to Y you
can enter Y if RCO2 supports warm ESA exit.