Nortel DMS-100 Series Reference Manual page 419

Datafilling table LCMINV
Subfield or
Field
refinement
LCMNM
SITE
FRNO
UNITNO
FRTYPE
EQPEC
LOAD
CSPMNO
Note 1: Make changes to fields with multiple entries in PROMPT mode only.
Note 2: When you enter data in fields link information (LNKINFO) or link map (LNKMAP), you
cannot assign message links to the same interface card. When the interface card supports two or
more links, separate the message links by the number of links on the interface cards. This
separation applies to all interface link types. The link interface types are DS-1, DS30, DS30A, or
PCM-30. Table control issues a warning if you attempt to assign message links on the same
interface card. The assignment of message links to the same interface card can cause an E1
outage if the card fails. An E1 outage is the failure of all message links.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling ISDN on RSC-S UK / Europe 4-169
Entry Explanation and action
refer to Line concentrating module name. Enter the
subfields LCM name. This field contains subfields SITE,
FRNO, and UNITNO.
alphanumeric Site. Enter the site name assigned to the
remote location.
0 to 511 Frame number. Enter the LCM frame number.
0 to1 Unit number. Enter the LCM unit number.
refer to list Frame type. Enter the frame type in which the
peripheral module equipment sits. Enter CRSC
for the RCO2 shelf. Enter CEXT for the RCO2
extension shelf.
Enter the location of the LCM in fields SHPOS,
FLOOR, ROW, and FRPOS.
refer to list Product engineering code (PEC) for frame
equipment. Enter the PEC for the frame type,
CRSC or CEXT, that contains the LCME.
alphanumeric Software load number. Contains the name of
the software issue.
refer to C-side PM number. Contains subfields
subfields PMTYPE and PMNO.
—continued—
ISDN operations
(continued)