Nortel DMS-100 Series Reference Manual page 235

Billing
Firmware downloading does not affect billing.
Station Message Detail Recording
Firmware downloading does not affect Station Message Detail Recording
(SMDR).
Entering office parameters
Firmware downloading does not affect office parameters.
Datafill sequence
The following table lists tables that require datafill to implement firmware
downloading. The list appears in the order you must enter.
Datafill tables required for firmware downloading
Table Purpose of table
PMLOADS PM loads. Stores the device location of every PM load file to map between load
names and devices where the loads reside. This condition permits autoload to
locate load files without personnel interruption. You must enter the expanded
peripheral module (XPM) load files in table PMLOADS before use in XPM
inventory tables.
LTCINV Line trunk controller inventory. Contains the inventory data for PM types. The
exception is the P-side link assignment. Use this table to define the PCM-30
line group controller (PLGC). You also use this table to define line group
controller overseas (LGCO) on the C-side of the RCO2.
RCCINV Remote cluster controller inventory. Contains inventory data for the RCO2. The
exception is P-side link assignments. You enter RCO2 C-side PCM-30
assignments in table RCCINV.
Entering table PMLOADS
Table PMLOADS stores the device location of every PM load file to map
between load names. Table PMLOADS also stores devices where the loads
reside. The PMs suspected of having a corrupt load are automatically
reloaded. Recovery time is reduced. This reduction permits autoload to
locate load files without interruption by personnel.
Table PMLOADS stores data for the following:
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling Firmware downloading on RSC-S International 3-211
name of the active loadfile—the default load used with the LOADPM
command and most system initiated activities
Firmware downloading
(continued)