Nortel DMS-100 Series Reference Manual page 57

Data entry tables for basic call processing
Table
RMMINV
LNINV
REXSCHED
TRKGRP
TRKSGRP
TRKMEM
ALMSCGRP
ALMSDGRP
ALMSD
ALMSC
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
(continued)
Purpose of table
Remote maintenance module inventory.
Identifies:
Line circuit inventory. Lists the data for each line card slot.
System REX scheduling of frequency and number of concurrent SREX
tests. Used along with parameter NODEREXCONTROL in table
OFCVAR to control the execution of SREX tests. The system adds
tuples to this table after you enter data in inventory tables.
Trunk group. Defines data for each trunk group that associates with the
switching unit.
Trunk subgroup. Lists additional information for each subgroup
assigned to one of the trunk group in table TRKGRP.
Trunk member. Lists data for each trunk assigned to one of the trunk
groups and subgroups specified in tables TRKGRP and TRKSGRP.
This table identifies the circuits for static trunks, dynamic trunks and the
test equipment you use to test lines and trunks.
Alarm scan group. Records the circuit equipment, location and type of
circuit pack that contains scan points.
Alarm signal distributor group. Records the circuit equipment, location,
and type of circuit pack that contains signal distribution (SD) points.
Alarm signal distributor point. Identifies the function performed by each
of the assigned signal distribution points in the alarm signal distributor
groups.
Alarm scan. Identifies the function performed by each of the assigned
scan points in the alarm scan groups.
—continued—
Datafilling BAS on RSC-S International 3-33
Basic call processing
RLCM
RSC-S or outside plant module (OPM) site with:
frame type, frame number, floor, row, frame
position, product engineering code (PEC), PM
load, and executive program loaded
C-side PM
These data attach to each remote maintenance
module (RMM).
(continued)