Nortel DMS-100 Series Reference Manual page 63

Datafilling table SITE
Table SITE contains data for the switching unit and for the remote locations
that use the switching unit. Enter data in table SITE to enable the DMS
system to recognize the equipment. Enter this data before you assign a line
equipment number, and enter data in a PM. The HOST for the switching
unit must be the first entry in table SITE. The operating company defines
the site names for the remote locations.
The following table describes entries specific to basic call processing for
table SITE. Fields that apply directly to basic call processing appear in the
table. Refer to the data schema section of the Translations Guide for a
description of the other fields.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Note: To use site names for a remote location, make sure that you enter
the two parameters set to Y correctly. Enter the parameters in table
OFCOPT (USINGSITE) and table OFCENG
(UNIQUE_BY_SITE_NUMBERING).
Datafilling BAS on RSC-S International 3-39
Basic call processing
(continued)