Nortel DMS-100 Series Reference Manual page 38

3-14 Datafilling BAS on RSC-S International
Basic call processing
Description
This description contains tables that apply directly to basic call processing.
For details on call translations, refer to the Translations Guide.
Basic call processing tables provide entries for:
DMS recognition of the switching unit and remote locations
The data in table SITE allows a DMS switch to recognize the equipment for
the switching unit. This data also allows the switch to recognize the
equipment for the remote locations that use the switching unit. Table SITE
defines site names for the remote location. Table SITE uses codes in table
CLLI for switching unit trunk groups and the remote location. Table CLLI
identifies the far end of each announcement, tone, trunk group, test trunk,
national milliwatt test lines and service circuit.
Physical device location identification data
Device location data for the major RSC-S components are in inventory
tables. These inventory tables include tables LCMINV, RCCINV and
RMMINV.
Link assignments for the RCO2 and peripherals
Link assignments are entered in tables LTCINV, LTCPSINV and
RCCPSINV.
297-8331-815 Standard 10.01 August 1999
(continued)
DMS recognition of the switching unit and all remote locations
physical device location identification data
link assignments for the RCO2 and peripherals
recovery
trunks and trunk groups
alarm functions
circuit test equipment
maintenance control for peripherals
REX scheduler
negate ground diagnostics that are not complete