Nortel DMS-100 Series Reference Manual page 291

Loading a PPXL
There are two ways to add PPXLs to an office. The first way is to upgrade
an office to a new base load lineup. This is possible when the base
loadname is not in table PMLOADS. The second way is to add PPXLs to
offices that have the base loadname in table PMLOADS. For example,
ESC03CJ, the current loadname attaches to ESC03CJ_950105, (the PPXL
added to the baseload). Descriptions of the two methods follow:
Note 1: Release BCS36 or higher CM loads supports PPXLs.
Note 2: Apply the PATCH JCK19 to the CM before you continue.
Upgrading the base load
To load a PPXL in an office where the baseload is new to the office, use the
following procedure:
1 Copy the base loadfile and the PPXL loadfiles to the disk volumes used
for PM loads.
Note: Copy the base load and the PPXL load to two disk volumes for
redundancy.
2 Copy the patches that associate with the PPXL loads to the same disk
volume used in the step 1. The load tape shipment includes a list of
patches that associate with each PPXL. When the disk contains the
PPXL file, obtain a list of patches included in the PPXL. To obtain a list
of patches included in the PPXL, type
>XPMLFP
and press the Enter key.
>PATCHLIST FILE ppxl_filename
and press the Enter key.
where
ppxl_filename
base load
3 Add a new tuple for the base load to table PMLOADS. Enter the base
load for the LOADNAME, and the ACTFILE. Enter the base load name
again for the BKPFILE.
4 Add the base loadname to the correct inventory table, for example
LTCINV.
5 Edit the tuple added in step 3 to change the ACTFILE field from the
base loadfile name to the PPXL filename. Refer to the entry example for
table PMLOADS to identify this tuple.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling BAS on RSC-S UK / Europe 4-41
Basic call processing
is the filename of the PPXL loaded added to the
(continued)