Nortel DMS-100 Series Reference Manual page 176

3-152 Datafilling ISDN on RSC-S International
ISDN operations
Defining service capabilities
These tables contain the attributes of the BRA:
Translations table flow
Enter data in some of the tables through SERVORD and not the table editor.
ISDN operations translations tables interactions
The following list describes ISDN operations translations tables:
297-8331-815 Standard 10.01 August 1999
(continued)
LTGRP (Logical Terminal Group)
LTDEF (Logical Terminal Definition)
LTMAP (Logical Terminal Map)
KSETINV (Key Set Inventory)
KSETLINE (Keyset Line)
KSETFEAT (Keyset Features)
Note: The SERVORD automatically fills some of these tables.
Table DATASIZE specifies the size of fixed tables. For BRI services,
enter data in table DATASIZE to specify the size needed for table
SPECCONN. If you set the size too low, table SPECCONN will be
corrupted.
Table DATASIZE is entered at the start with default table size values for
RSC-S tables CLLI, SPECCONN, TRKGRP, and TRKSGRP.
Table SITE. Identifies the equipment for the switching unit and for all
remote locations that connect to the limit. This table contains data
before you can assign a LEN or a PM. The host switching unit is the
first entry in this field. Field NAME associates with the number
required to dial the site, and alarm data for remote sites. Table SITE
uses the same CLLI tuple for operator verification as the CLLI tuple
datafilled in table CLLI.
The table SITE (field NAME) must know the field SITE in table
LCMINV and the field SITENM in tables RCCINV and RMMINV. The
table SITE (field NAME) must know the subfield SITE_ID in table
ISTRKGRP.