Nortel DMS-100 Series Reference Manual page 471

Display one or more tuples in a table that binds to CDT management.
To display the tuples, enter the CHNL:PROT level of PMDEBUG
command, and type:
<DISPTBL table_id [<tuple_no> | R <begtuple> <endtuple> | all ]
where
table_id
tuple_no
R
begtuple
endtuple
all
and press Enter.
If table identification is given, every tuple appears in the list. Press
the RETURN key to abort list creation.
Bulk data update
When the two units of the RSC-M are InSv, the inactive unit requests a bulk
transfer of critical dynamic data. The inactive unit requests the data from
the active unit. These data help to maintain established calls and continue
call processing if a SWACT occurs. This bulk transfer is a bulk data update.
If the inactive unit is out-of-service (OOS), the inactive unit requests a bulk
data update when an RTS occurs.
Bulk data include:
AN status data
P-side status data
C-side status (open/closed) data
call processing data
An example of call processing data is the connection of a specified line
circuit to a specified PCM30 channel.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Introduction to Remote Switching Center Multi-access 5-11
is the name of the table that appears
is the number of a specified tuple that appears
is a range of tuples that appear
is the beginning tuple of the range
is the end tuple of the range
is display every tuple in the table