Nortel DMS-100 Series Reference Manual page 87

Datafilling table RCCINV
Subfield or
Field
refinement
RCCNAME
SITE
PMTYPE
RCCNO
FRTYPE
EQPEC
LOAD
EXECTAB
TRMTYPE
Note: When you enter data in field C-side link table (CSLNKTAB), make sure message links are
not assigned to the same interface card. When the interface card supports two or more links,
separate the message links by the number of links on the interface cards. This action applies to all
interface link types: DS-1, DS30, DS30A, or PCM-30. If an attempt to assign message links is
made on the same interface card, table control issues a warning. The assignment of message links
to the same interface card can cause an E1 outage (failure of all message links). The E1 outage
can occur if the card fails.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling BAS on RSC-S International
Basic call processing
Entry Explanation and action
refer to RCO2 name. Contains subfields SITE,
subfields PMTYPE, and RCCNO.
alphanumeric Site. Enter the site name assigned to the
remote location. This entry must appear in
table SITE.
RCO2 PM type. Enter RCO2.
0 to 511 RCO2 number. This number is different by
office and not by site.
see list Frame type. Enter CRSC for the RCO2 shelf.
Enter CEXT for the RCO2 extension shelf.
Enter the location of the RCO2 in fields FRNO,
SHPOS, FLOOR, ROW, and FRPOS.
MX85AA Equipment PEC. Enter the PEC MX85AA for
the RCO2.
alphanumeric Load. Enter the load for the RCO2. Make sure
that table PMLOADS contains this datafill.
refer to Exec table. Contains subfields TRMTYPE,
subfields EXEC, and CONTMARK. As with LTCINV,
each terminal type associates with the particular
execs.
Note: Changes to fields with multiple entries
must be made in the PROMPT mode only.
refer to list Terminal type. Enter the terminal models that
will be used. The POTS is for normal lines. The
KEYSET is for MBS/data lines. The
RMM_TERM is for remote MTC trunks. The
ABTRK is for normal trunks, and the ESA is for
ESA lines.
—continued—
3-63
(continued)