Nortel DMS-100 Series Reference Manual page 90

3-66 Datafilling BAS on RSC-S International
Basic call processing
Datafilling table RCCINV
Subfield or
Field
refinement
CMRLOAD
TONESET
PROCPEC
E2LOAD
Note: When you enter data in field C-side link table (CSLNKTAB), make sure message links are
not assigned to the same interface card. When the interface card supports two or more links,
separate the message links by the number of links on the interface cards. This action applies to all
interface link types: DS-1, DS30, DS30A, or PCM-30. If an attempt to assign message links is
made on the same interface card, table control issues a warning. The assignment of message links
to the same interface card can cause an E1 outage (failure of all message links). The E1 outage
can occur if the card fails.
297-8331-815 Standard 10.01 August 1999
(continued)
(continued)
Entry
alphanumeric
AUS100,
CHINA100,
or DEFAULT
MX77AA
MX77AA or
AX74AA
AX74AA
alphanumeric
—continued—
Explanation and action
CLASS modem resource load. If the CMR card
is used the card must be followed by the CMR
loadname. Enter the CMR loadname.
Tone set. Enter AUS100 for international
applications or CHINA100 for China.
Otherwise, enter a blank for DEFAULT.
Processor equipment product engineering
codes. Enter the PEC of the 6X45 type card in
units 0 and 1 of the RCO2. The PEC must
reflect the minimum firmware capabilities in the
processor complex of each unit. For RCO2,
entry value AX74AA has been added.
Note: When the NT7X05 PRL is entered as an
optional card, enter MX77AA MX77AA.
AX74AA AX74AA is not allowed as a valid value
when the NT7X05 PRL is entered as an
optional card because the NTAX74 CAP does
not support NT7X05 PRL functionality.
EEPROM file. Contains the name of the loadfile
loaded in the NTMX77AA EEPROM or the
optional NTAX74AA EEPROM.
Note: When the NT7X05 PRL is datafilled as
an optional card, enter the loadfile name for the
NTMX77 UP. The optional NTAX74AA CAP
does not support NT7X05 PRL functionality.