Nortel DMS-100 Series Reference Manual page 75

Datafilling table LTCINV
Subfield or
Field
refinement
NMPAIR
NMPORT
OPTCARD
TONESET
PROCPEC
E2LOAD
OPTATTR
Note 1: Make changes to fields with multiple entries in the PROMPT mode. In nonprompt mode,
leave out current entries.
Note 2: Enter the continuation mark (+) in fields with multiple possible entries when the next line
specifies more data or when you enter more records. Enter the end mark ($) in fields with multiple
possible entries after the last entry.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
(continued)
Entry
0 to 31
0 to 63
see list
AUS100
MX77AA
MX77AA or
AX74AA
AX74AA
alphanumeric
—continued—
Datafilling BAS on RSC-S International 3-51
Basic call processing
Description
Network module pair number. Enter the
network link where the PM is assigned,
corresponding to PM C-side links 0 through 15.
Network module port. Enter the network port
corresponding to the above link.
Optional card. This field is a vector with up to
ten entries. Enter this when the PLGC/LGCO
includes the UTR or GTR TONE, message card
and the NT7X05 Peripheral/Remote Loader-16
(PRL). If the CMR card is included, enter the
CMRLOAD.
Note 1: Changes to fields with multiple entries
must occur in the PROMPT mode.
TONESET. Enter AUS100. Range of values
include DEFAULT, NORTHAM, CHINA100, and
AUS100.
Processor equipment product engineering
codes. One PEC is required for each LTCO
unit. Enter the PEC for unit 0 first. The PEC
must reflect the minimum firmware capabilities
in the processor complex of each unit.
EEPROM file. Contains the name of the loadfile
loaded in either the NTMX77AA EEPROM or
the optional NTAX74AA EEPROM.
Note: When the NT7X05 PRL is entered as an
optional card, enter the loadfile name for the
NTMX77 UP. The optional NTAX74AA CAP
does not support NT7X05 PRL functionality.
Optional attribute. Since this is not a DTC for
CCS7, leave blank. Subfield: CONTMARK.
(continued)