Nortel DMS-100 Series Reference Manual page 199

Note 1:
alphanumeric entries, for example
Note 2: If the shelf has a processor other than NTMX77 or the optional
NTAX74, the following occurs. The system automatically enters field
E2LOAD with value NILLOAD.
Note 3: When you enter field PROCPEC with AX74AA AX74AA instead
of MX77AA MX77AA, the following occurs. The load name prefix in field
LOAD changes from
changes to
datafill for table RCCINV when you enter the RCO2 for the NTAX74AA
CAP.
MAP example for table RCCINV entered for NTAX74AA CAP
Datafilling table RCCPSINV
The remote cluster controller P-side inventory (RCCPSINV) table contains
only the P-side link assignments for the RCO2. You can enter a maximum
of 54, 0 through 53, multiples of P-side link information for the RCO2.
When you add an extension shelf, datafill limits apply for RCO2 P-side links
connected to the extension shelf. You can enter the PCM-30 and DCH links
that connect to the extension shelf if you entered an extension shelf in table
RCCINV. You must change all links connected to the extension shelf from
D30 or DCH to NILTYPE or DS30A in table RCCPSINV. Perform this
procedure before you delete the extension shelf from table RCCINV.
You can enter a maximum of ten DCH cards in table RCCPSINV.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
in field LOAD and
xx
KRI
(for AX74AA). The following example shows sample
WRI07XX
RCCNAME FRTYPE FRNO SHPOS FLOOR ROW FRPOS EQPEC
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
MELB RCO2 0 CRSC 0
EXECTAB
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
(POTS POTSEX)(RMM_TERM RSMEX)(ESALINES ESAEX)
CSPM CSLNKTAB
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
PLGC 0 (0) (1) (2) (3) (4) (5) (6) (7)
ESA INTRASW OPTCARD
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
N N (UTR5)(ISP16)
TONESET PROCPEC
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
AUS100 MX77AA MX77AA
Datafilling ISDN on RSC-S International 3-175
ISDN operations
in field E2LOAD represent
xxxx
and
B1 XE01
to . For example,
WRI
0 3 C 18
E2LOAD
MX77xxxx
(continued)
, in the order given.
(for MX77)
KRI07xx
LOAD
MX85AA KRI06xx
CONTMARK
$
CONTMARK
$
CONTMARK
$