Nortel DMS-100 Series Reference Manual page 198
Extended peripheral module
Hide thumbs
Also See for DMS-100 Series:
- Replacement procedures (1100 pages) ,
- Maintenance manual (762 pages) ,
- Manual (543 pages)
Table of Contents
Advertisement
3-174 Datafilling ISDN on RSC-S International
ISDN operations
Datafilling table RCCINV
Subfield or
Field
refinement
OPTCARD
Note 1: The designator of the enhanced ISDN signal processor (NTBX01BA) card is ISP16. You
require NTBX01BA when an RCO2 is equipped with the NTAX74AA Cellular Access Processor
(CAP).
Note 2: When you enter field C-side link table (CSLNKTAB), do not assign links to the same
physical interface card. When the interface card supports two or more links, separate the message
links by the number of links on the interface cards. This procedure applies to all interface link types:
DS-1, DS30, DS30A, or PCM-30. Table control issues a warning if you make an attempt to assign
message links on the same interface card. If you assign message links to the same interface card,
an E1 outage can result. An E1 outage is the failure of all message links.
Datafill example for table RCCINV
The following examples show sample datafill for table RCCINV. The
samples are for an RCO2 with the NTMX77AA UP and an RCO2 with the
optional NTAX74AA CAP, in that order.
MAP example for table RCCINV entered for NTMX77AA UP
297-8331-815 Standard 10.01 August 1999
(continued)
Entry
ISP16
RCCNAME
FRTYPE FRNO SHPOS FLOOR ROW FRPOS EQPEC
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
MELB RCO2 0 CRSC
0
EXECTAB
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
(POTS POTSEX)(RMM_TERM RSMEX)(ESALINES ESAEX)
CSPM
CSLNKTAB
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
PLGC 0
(0) (1) (2) (3) (4) (5) (6) (7)
ESA INTRASW
OPTCARD
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
N
N
(UTR5)(ISP16) (7X05)
TONESET
PROCPEC
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
AUS100
MX77AA
MX77AA
Explanation and action
Optional card. This is a vector of a maximum of
10 entries. Examples: UTR14, UTR6, UTR7,
CMR18, ISP16, PRL.
Note: Make changes to fields with multiple
entries in the PROMPT mode only.
0
3
C
18
E2LOAD
MX77xxxx
LOAD
MX85AA
KRI06xx
CONTMARK
$
CONTMARK
$
CONTMARK
$
Advertisement
Table of Contents
