Nortel DMS-100 Series Reference Manual page 455

The datafill that applies to downloads for table PMLOADS appears in the
following table. Only the fields that apply directly to firmware downloads
appear. Refer to the data schema section of the Translations Guide for a
description of the other fields.
Datafilling table PMLOADS
Subfield or
Field
refinement
LOADNAME
ACTFILE
ACTVOL
BKPFILE
BKPVOL
UPDACT
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling Firmware downloading on RSC-S UK / Europe 4-205
Firmware downloading
Entry Explanation and action
alphanumeric Peripheral module load name. Enter the XPM
load name. Range is a maximum of 32
characters. This loadname must be the same
as the load name datafill in tables LTCINV and
RCCINV.
alphanumeric Active load file name. The name of the active
XPM loadfile. This loadfill can be the original
loadfile or a patched loadfile. Name contains a
maximum of 32 characters. Before patching,
this name is the original load name. The XPM
load file patching updates the field. This
condition occurs after the load patches for a
period of time. This period is called soak time.
alphanumeric Active volume. Identifies the device that
contains the active loadfile. Range is the set of
disk drive unit (DDU) volumes and system load
module (SLM) disks available to the CM or
S00DXPM. Name contains a maximum of 16
characters.
alphanumeric Backup load file name. Identifies the name of
the backup XPM loadfile. The name must be
the same name as the LOADNAME field.
Name contains a maximum of 32 characters.
alphanumeric Backup volume. The device that contains the
backup loadfile. Range is the set of DDU
volumes and SLM disks available to the CM or
S00DXPM. Name contains a maximum 16
characters.
Y or N Update active filename. Controls if loadfile
patching can occur on the loadfile. Controls if
system updates table PMLOADS fields
ACTFILE and ACTVOL with the patched loadfile
name.
(continued)