Nortel DMS-100 Series Reference Manual page 427

Datafilling table LNINV
Table LNINV lists data for each line card slot. The LEN tuple in table
LNINV corresponds to the LEN tuple in table LTMAP. With ISDN lines,
the values for some of the fields change.
Only fields that apply to the ISDN on RSC-S appear in the datafill example
for table LNINV. Refer to the data design section of the Translations Guide
for a description of the other fields.
Datafilling table LNINV
Subfield or
Field
refinement
LEN
SITE
FRAME
UNIT
LSG
LEN CIRCUIT
(continued)
CARDCODE
STATUS
GND
BNV
Note: To set up a connection for the four D-channels to one DCH card BRA port, define a LEN as
working. Define the LEN in table LNINV. The system maps together the first four ISDN lines in the
LCME defined as working in the same drawer.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling ISDN on RSC-S UK / Europe 4-177
Entry Explanation and action
refer to Contains subfields SITE, FRAME, UNIT, LSG,
subfields and CIRCUIT.
alphanumeric Site. Enter the site name assigned to the
remote location.
0 to 99 Frame. Enter the frame number.
0 to 1 Unit. Enter the unit number.
0 to 23 Line subgroup. Enter the LSG.
0 to 15 Circuit. Enter the circuit number of the line
card. Note that for ISDN lines the range is 0 to
15. The range is not 0 to 31.
BX27AA Card code. Enter BX27AA for ISDN line cards
in the LCME.
WORKING Line inventory available state. Enter HASU,
WORKING, UNEQUIP, CUTOFF, or
RESERVED. You normally control the field
RESERVED through SERVORD. The
recommended entry is the field WORKING.
N Ground. For ISDN lines, enter N.
NIL Balanced network value. The ISDN lines have
a non-loaded network value. Enter NL.
—continued—
ISDN operations
(continued)