Nortel DMS-100 Series Reference Manual page 378

4-128 Datafilling PCM-30 trunks on RSC-S UK / Europe
PCM-30 R1 Trunking
Datafill tables required for PCM-30 R1 Trunking
Table
CLLI
SITE
PMLOADS
CARRMTC
RCCINV
RCCPSINV
TRKGRP
TRKSGRP
TRKMEM
297-8331-815 Standard 10.01 August 1999
(continued)
Purpose of table
Common language location identifier. Contains codes that identify the
far end of each announcement, tone, trunk group, test trunk, national
milliwatt test lines and service circuit.
Site. Contains data that allows the DMS system to recognize
equipment for the switching unit. This data allows the DMS to recognize
equipment for all remote locations that connect to the switching unit.
Peripheral module loads. Stores the device location of each peripheral
module (PM) load file to map between the load names and load
devices. The system enters data in the first loads.
Carrier maintenance. Allows the DMS switch administration to enter
maintenance control information in peripherals, OOS limits for alarms
and system return-to-service (RTS) occurrences.
Remote cluster controller inventory. Contains inventory data for the
RCO2. Does not contain P-side link assignments. Table RCCINV
contains RCO2 C-side DS-1 assignments.
Remote cluster controller P-side link inventory (RCCPSINV). The
RCCPSINV contains the RCO2 P-side link assignments.
Trunk group. Defines data for each trunk group that associates with the
switching unit.
Trunk subgroup. Lists additional information for each subgroup
assigned to a trunk group listed in table TRKGRP.
Trunk member. Lists data associated with each trunk assigned to one
of the trunk groups and subgroups that tables TRKGRP and TRKSGRP
specify. This table identifies circuits associated with static trunks,
dynamic trunks and the test equipment to test lines and trunks.