Custom Daylight Saving Time Configuration
396
G8264 Command Reference for ENOS 8.4
Use these commands to configure custom Daylight Saving Time. The DST is
defined by two rules, the start rule and end rule. The rules specify the dates when
the DST starts and finishes. These dates are represented as specific calendar dates
or as relative offsets in a month (for example, ʹthe second Sunday of Septemberʹ).
Relative offset example:
2070901 = Second Sunday of September, at 1:00 a.m.
Calendar date example:
0070901 = September 7, at 1:00 a.m.
Table 175.
Custom DST Options
Command Syntax and Usage
[no] system customdst enable
Enables or disables the Custom Daylight Saving Time settings.
Command mode: Global configuration
system customdst startrule <WDDMMhh>
Configures the start date for custom DST, as follows:
WDMMhh
W = week (0‐5, where 0 means use the calendar date)
D = day of the week (01‐07, where 01 is Monday)
MM = month (1‐12)
hh = hour (0‐23)
Note: Week 5 is always considered to be the last week of the month.
Command mode: Global configuration
system customdst endrule <WDDMMhh>
Configures the end date for custom DST, as follows:
WDMMhh
W = week (0‐5, where 0 means use the calendar date)
D = day of the week (01‐07, where 01 is Monday)
MM = month (1‐12)
hh = hour (0‐23)
Note: Week 5 is always considered to be the last week of the month.
Command mode: Global configuration
show customdst
Displays the current Custom DST configuration.
Command mode: All