Table of Contents
Advertisement
Chapter 1. ThinkSystem NE0152T
Port Configuration
Transceiver Configuration
Orientation, Airflow, and Redundancy
Management
Additional Features
© Copyright Lenovo 2018
This Installation Guide provides information about the Lenovo RackSwitch Lenovo
ThinkSystem NE0152T RackSwitch (referred to as NE0152T throughout this
document).
The NE0152T uses a wire-speed, non-blocking switching fabric that provides
simultaneous wire-speed transport of multiple packets at low latency on all ports.
The NE0152T contains the following ethernet ports:
Forty-eight 10/100/1000 BASE-T RJ45 ports
Four 10 GbE Small Form Pluggable Plus (SFP+) ports
The 10/100/1000 BASE-T RJ45 ports can be populated with CAT5E copper cabling.
SFP+ ports, when used in 10 GbE mode, can be populated with optical transceiver
modules or active or passive Direct-Attach Cables (DACs). When used in legacy
1 GbE mode, the ports can be populated with optical or copper transceiver modules.
The NE0152T is 1U in height and can be mounted horizontally or vertically,
depending on your application. Mounting options are available for a variety of rack
systems.
For superior reliability, the NE0152T uses redundant, hot-swap power supply
modules and three hot-swap fan modules. Module options are available for either
front-to-rear airflow, or rear-to-front airflow.
You can manage the switch through the local console port, or through a remote
network connection, or SNMP-based network management software.
Other features supported on your switch depend on the specific firmware installed.
For more information, see the Application Guide and Command Reference for your
specific switch and its installed firmware.
15
Advertisement
Table of Contents
