Lenovo RackSwitch G8264 Command Reference Manual page 23

Table 2. ISCLI Command Modes (continued)
Command Mode/Prompt
Interface loopback
RS G8264(config­ip­loopback)#
Interface port
RS G8264(config­if)#
Interface PortChannel
RS G8264(config­PortChannel)#
VLAN
RS G8264(config­vlan)#
Router OSPF
RS G8264(config­router­ospf)#
Router OSPFv3
RS G8264(config­router­ospf3)#
Router BGP
RS G8264(config­router­bgp)#
© Copyright Lenovo 2017
Command used to enter or exit
Enter Interface Loopback Configuration mode, from Global
Configuration mode:
interface loopback <1‐5>
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
Enter Port Configuration mode, from Global Configuration
mode:
interface port <port alias or number>
Exit to Privileged EXEC mode: exit
Exit to Global Configuration mode: end
Enter PortChannel Configuration mode, from Global
Configuration mode:
interface portchannel {<1‐128>|lacp <key>}
Exit to Privileged EXEC mode: exit
Exit to Global Configuration mode: end
Enter VLAN Configuration mode, from Global Configuration
mode:
vlan <VLAN ID (1‐4094)>
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
Enter OSPF Configuration mode, from Global Configuration
mode:
router ospf
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
Enter OSPFv3 Configuration mode, from Global Configuration
mode:
ipv6 router ospf
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
Enter BGP Configuration mode, from Global Configuration
mode:
router bgp
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
23
Chapter 1: ISCLI Basics