802.1X Global Configuration - Lenovo RackSwitch G8264 Command Reference Manual

802.1X Global Configuration

456
G8264 Command Reference for ENOS 8.4
The global 802.1X commands allow you to configure parameters that affect all
ports in the switch.
Table 224.
802.1X Global Configuration Options
Command Syntax and Usage
dot1x max­request <1‐10>
Sets the maximum number of times the authenticator retransmits an
EAP‐Request packet to the supplicant (client).
The default value is 2.
Command mode: Global configuration
dot1x mode {force­unauthorized|auto|force­authorized}
Sets the type of access control for all ports:
force­unauthorized ‐ the port is unauthorized unconditionally.

auto ‐ the port is unauthorized until it is successfully authorized by the

RADIUS server.
force­authorized ‐ the port is authorized unconditionally, allowing all

traffic.
The default value is force­authorized.
Command mode: Global configuration
dot1x quiet­time <0‐65535>
Sets the time, in seconds, the authenticator waits before transmitting an
EAP‐Request/ Identity frame to the supplicant (client) after an authentication
failure in the previous round of authentication.
The default value is 60 seconds.
Command mode: Global configuration
[no] dot1x re­authenticate
Sets the re‐authentication status to on or off.
The default value is off.
Command mode: Global configuration
dot1x re­authentication­interval <1‐604800>
Sets the time, in seconds, the authenticator waits before re‐authenticating a
supplicant (client) when periodic re‐authentication is enabled.
The default value is 3600 seconds.
Command mode: Global configuration