USB Copy
Copy to USB
Copy from USB
678
G8264 Command Reference for ENOS 8.4
If a USB drive is inserted into the USB port, you can copy files from the switch to
the USB drive, or from the USB drive to the switch. You also can boot the switch
using software or configuration files found on the USB drive (see "USB Boot
Configuration" on page
Use the following command to copy a file from the switch to the USB drive:
usbcopy tousb <filename> {active|boot|crashdump|image1|image2|
|syslog}
Command mode: Privileged EXEC
Note: Not available in stacking.
In this example, the active configuration file is copied to a directory on the USB
drive:
RS G8264# usbcopy tousb a_folder/myconfig.cfg active
Use the following command to copy a file from the USB drive to the switch:
usbcopy fromusb <filename> {active|boot|image1|image2}
Command mode: Privileged EXEC
Note: Not available in stacking.
In this example, the active configuration file is copied from a directory on the USB
drive:
RS G8264# usbcopy fromusb a_folder/myconfig.cfg active
The new file replaces the current file.
Note: Do not use two consecutive dot characters ( .. ). Do not use a slash character
( / ) to begin a filename.
706).