Saving the Switch Configuration
1. Set the FTP, SFTP, or TFTP server address where the configuration file is saved:
2. Set the name of the configuration file:
3. If you are using an FTP or SFTP server, enter a username:
4. If you are using an FTP or SFTP server, enter a password:
5. Initiate the transfer. To save a running configuration file, enter 4:
Saving a Switch Dump
1. Set the FTP, SFTP, or TFTP server address where the configuration will be saved:
2. Set the name of dump file:
3. If you are using an FTP or SFTP server, enter a username:
4. If you are using an FTP or SFTP server, enter a password:
5. Initiate the transfer. To save a dump file, enter 5:
© Copyright Lenovo 2016
To save the switch configuration to a file server, follow these steps. This example
shows an FTP, SFTP, or TFTP server at IPv4 address 192.168.10.10, though IPv6 is
also supported.
Set agTransferServer.0 "192.168.10.10"
Set agTransferCfgFileName.0 "MyRunningConfig.cfg"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "4"
To save a switch dump to a file server, follow these steps. This example shows an
FTP, SFTP, or TFTP server at 192.168.10.10, though IPv6 is also supported.
Set agTransferServer.0 "192.168.10.10"
Set agTransferDumpFileName.0 "MyDumpFile.dmp"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "5"
Chapter 41: Simple Network Management Protocol
657