Lenovo RackSwitch G8264 Command Reference Manual page 668

668
G8264 Command Reference for ENOS 8.4
Table 378.
Static Flow Matching Qualifiers in OpenFlow 1.3
Qualifier
udp‐src
udp‐dst
icmpv4‐type
icmpv4‐code
eth‐type
ip‐proto
ip‐dscp
arp‐op
mpls‐label
all
The following table describes the available actions:
Table 379.
Static Flow Actions in OpenFlow 1.0
Action
output
set‐src‐mac
set‐dst‐mac
strip‐vlan‐id
set‐vlan‐priority
set‐nw‐tos
drop
max‐len
Table 380.
Static Flow Actions in OpenFlow 1.3
Action
output
output‐portchannel
set‐eth‐src
set‐eth‐dst
push‐vlan
pop‐vlan
Value
UDP source port (0‐65535)
UDP destination port (0‐65535)
ICMPv4 type
ICMPv4 code
ʺarpʺ/ʺ0806ʺ or ʺipʺ/ʺ0800ʺ or (hex‐value < =65535)
ʺtcpʺ or ʺudpʺ or 0‐255
IP DSCP (6 bits in ToS field)
ʺrequestʺ or ʺreplyʺ (can be set only if eth‐type is ARP)
MPLS label
all qualifiers or any qualifier
Value
ʺallʺ,ʺin‐portʺ,ʺcontrollerʺ or a valid port
Change source MAC address
Change destination MAC address
Remove VLAN identifier
Set 802.1p priority code point value (0‐7)
Set IP Type of Service (0‐255)
Drop packet
Maximum length to send to controller
Value
ʺallʺ,ʺin‐portʺ,ʺcontrollerʺ or a valid port
output on a valid portchannel (static LAG or static
LACP LAG)
change source MAC address
change destination MAC address
push a new VLAN tag
pop the outer VLAN tag