Routing Map Configuration
© Copyright Lenovo 2017
Routing maps control and modify routing information.
Note: The map number (1‐255) represents the routing map you wish to configure.
Table 273.
Routing Map Configuration Options
Command Syntax and Usage
routemap <1‐255>
Enter route map configuration mode.
Command mode: Global configuration
accesslist <1‐32>
Configures the Access List. For more information, see page
Command mode: Route map
aspathlist <1‐8>
Configures the Autonomous System (AS) Filter. For more information, see
page
529.
Command mode: Route map
aspathpreference <1‐65535>
Sets the AS path preference of the matched route. You can configure up to 32
path preferences.
Command mode: Route map
no aspathpreference
Removes the AS path preference of the current route map.
Command mode: Route map
[no] enable
Enables or disables the route map.
Command mode: Route map
localpreference <0‐4294967294>
Sets the local preference of the matched route, which affects both inbound and
outbound directions. The path with the higher preference is preferred.
Command mode: Route map
no localpreference
Removes the local preference of the current route map.
Command mode: Route map
metric <1‐4294967294>
Sets the metric of the matched route.
Command mode: Route map
526.
Chapter 4: Configuration Commands
523